General purpose Piezo-tronic IEPE accelerometer, identical
in sensitivity range to A/120/V, but with annular through whole fixing allowing
full 360 degree connector orientation, reduced weight and height. Konic shear®
mechanically preloaded ceramic sensing element in addition to the welded case
seal, maximizes measurement integrity and reliability. A/122/V will
interface directly to spectrum analyzers having minimum 15V, 2mA transducer
outlet, bearing in mind that the minimal supply may constrain high frequency
capability, due to drive limitations, and dynamic range at elevated
temperature. Note that low level measurements are subject to signal/ noise
constraints but may be realizable if band width is restricted.
All DJB Accelerometers are calibrated on site prior to despatch, and are accompanied by a calibration chart with temperature and frequency responses listed.
Periodic calibration can be carried out with our VC-01 Handheld Calibrator whilst we also offer a full calibration service including cross axis checks to aid accuracy of data.
We are able to provide this service for all makes of accelerometer with a full report given for each device. Please contact us with an enquiry
Cable Assembly and Repair Service
- Cable Repair Service to make current cabling as good as new, cutting costs whilst good for the environment
- Specialist Cable Assembly - for all manufacturers
- Cable and connector stock held for a quick turnaround