Piezo-Tronic IEPE Accelerometer - A/122/E

10mV/g up to 500mV/g (±10%) ∙ 12gm ∙ -55°C to 125°C

Features

• Lightweight Design
• 10/32UNF Microdot Connector
• 360°C Mounting.

Applications

Modal Analysis of lightweight structures
Automotive
Aerospace
High Temperature
Impact Testing
Industrial
Exhaust Testing
Turbo Charger Testing
Vibration Shaker Testing
Structural Testing
General Vibration Measurement

General purpose Piezo-tronic IEPE accelerometer, identical in sensitivity range to A/120/V, but with annular through whole fixing allowing full 360 degree connector orientation, reduced weight and height. Konic shear® mechanically preloaded ceramic sensing element in addition to the welded case seal, maximizes measurement integrity and reliability. A/122/V will interface directly to spectrum analyzers having minimum 15V, 2mA transducer outlet, bearing in mind that the minimal supply may constrain high frequency capability, due to drive limitations, and dynamic range at elevated temperature. Note that low level measurements are subject to signal/ noise constraints but may be realizable if band width is restricted.

Calibration

All DJB Accelerometers are calibrated on site prior to despatch, and are accompanied by a calibration chart with temperature and frequency responses listed. Periodic calibration can be carried out with our VC-01 Handheld Calibrator whilst we also offer a full calibration service including cross axis checks to aid accuracy of data. We are able to provide this service for all makes of accelerometer with a full report given for each device. Please contact us with an enquiry

Cable Assembly and Repair Service

Cable Repair Service to make current cabling as good as new, cutting costs whilst good for the environment
Specialist Cable Assembly - for all manufacturers
Cable and connector stock held for a quick turnaround