Lightweight triaxial vibration transducer compromising
three, Konic Shear IEPE, all welded inserts, bonded orthogonally into hard
anodized aluminium housing. The inserts are electrically insulated,
individually and from the housing, thus eliminating ground loop interference.
Low impedance O/P provides a high degree of noise immunity (80dB improvement
vs. equiv. charge source device @ 50Hz) and allows use with low cost coaxial
cable. The additional mechanical isolation implicit in the construction
provides also near elimination of strain induced error. All the 3x10-32 UNF
Microdot connectors are exiting in the same direction.
The d33 component suppression property of the Konic design,
provides a minimization of cross axis error, and is particularly advantageous
for three axis measurement integrity.
The multi sensor solution also offers the benefit of being
repairable. If an insert is damaged it can usually be removed and replaced
saving the cost of a new accelerometer
All DJB Accelerometers are calibrated on site prior to despatch, and are accompanied by a calibration chart with temperature and frequency responses listed.
Periodic calibration can be carried out with our VC-01 Handheld Calibrator whilst we also offer a full calibration service including cross axis checks to aid accuracy of data.
We are able to provide this service for all makes of accelerometer with a full report given for each device. Please contact us with an enquiry
Cable Assembly and Repair Service
- Cable Repair Service to make current cabling as good as new, cutting costs whilst good for the environment
- Specialist Cable Assembly - for all manufacturers
- Cable and connector stock held for a quick turnaround