General purpose triaxial vibration transducer compromising
three, Konic Shear IEPE welded inserts, bonded orthogonally into hard anodized
aluminium housing. The inserts are electrically insulated, individually and
from the housing, thus eliminating ground loop interference. Low impedance O/P
provides a high degree of noise immunity (80 db improvement vs. equiv, charge
source device@ 50Hz) and allows use with low cost coaxial cable. The additional
mechanical isolation implicit in the construction provides also near
elimination of strain induced error.
The d33 component suppression property of the Konic design,
resulting in minimization of cross axis error, is particularly advantageous for
three axis measurement integrity.
The multi sensor solution also offers the benefit of being
repairable. If an insert is damaged it can usually be removed and replaced
saving the cost of a new accelerometer
Tri-axial Mounting Block - A/130.Shim
The A/130.shim has been designed for use with the A/130/V.1
specifically for 5000g triaxial shock measurements, it provides a flexible
mounting plate for modification to suit oddly shaped surfaces
Dimensions: 25.4 x 25.4 x 5mm think
3 x 3mmΦ mounting holes
All DJB Accelerometers are calibrated on site prior to despatch, and are accompanied by a calibration chart with temperature and frequency responses listed.
Periodic calibration can be carried out with our VC-01 Handheld Calibrator whilst we also offer a full calibration service including cross axis checks to aid accuracy of data.
We are able to provide this service for all makes of accelerometer with a full report given for each device. Please contact us with an enquiry
Cable Assembly and Repair Service
- Cable Repair Service to make current cabling as good as new, cutting costs whilst good for the environment
- Specialist Cable Assembly - for all manufacturers
- Cable and connector stock held for a quick turnaround